SVX8004 IP PBX System User Guide
陈泽科技有限公司
- 7 -
www.stephen-tele.com
Typical scenario B:
Connect with traditional PBX
(Suitable for SVX8004 IP PBX with 4 lines)
2.6.2.
Connect the power
Plug the DC end of the power adapter to the power socket on the device and the other end to an available power outlet. Press the
power switch ON at the back of the device to start the device. The PWR indicator light will be lit if power is connected correctly.
WARNING!
Never use a power adapter other than the one provided with SVX8004 IP PBX.
2.6.3.
System Startup
The STS light on the front panel will flash for a few moments during boot-up, and then remain lit, indicating the device is on.
2.6.4.
Connect the network
Connect the LAN port on the device to a Router/Switch by cable. The LAN indicator will lit if connected correctly.
2.6.5.
Connect the computer
Connect a computer to the same Switch or Router as SVX8004 IP PBX, so the SVX8004 IP PBX can be accessed through the network.
2.6.6.
Connect the telephone
Connect one end of the provided RJ-11 telephone cable to the Phone jack and the other end to your phone. You can hear some
signal tone from the earpiece when you pick up the telephone handset.
NOTE:
