11
INSSTE402P0711
4. Troubleshooting
Problem
Solution
The thermostat is hot.
In normal operating conditions, the thermostat housing can
reach nearly 40°C at maximum load.
That is normal and will not affect the effective operation of the
thermostat.
Heating is always on.
Check if the thermostat is properly connected. Refer to the
installation section.
Heating does not run even if the
thermostat indicates it is on.
Check if the thermostat is properly connected. Refer to the
installation section.
The display does not come on.
Check if the thermostat is properly connected. Refer to the
installation section. Check the power supply at the electrical
panel. Ensure that the heating unit has a switch. If so, ensure
that this switch is turned on.
The display turns off a few
minutes and then turns on again.
The thermal protection of the heating unit has deactivated the
unit due to overheating. Ensure that the heating unit is in good
condition of operation and that clearance around the appliance
is according to the manufacturer’s specifications.
The display has low contrast
when heating is on.
The load is lower than the minimum load. Install a heating unit
that is within the load limits of the thermostat.
The displayed ambient
temperature is incorrect.
Check the presence of an air stream or a heat source near the
thermostat, and correct the situation.
The display indicates E1 or E2.
Faulty thermal sensor. Contact the customer service.
Weak luminosity of the display.
Possibility of a bad contact. Check thermostat wirings. Refer to
the installation section.
