6939500000
17
mode remains deactivated when switching the
machine off and on again.
PREPARING FOR TIG
WELDING
a
Signal of water cooler enabled*;
b
Signal of pulsation enabled;
c
Access to
JOB LIST
menu;
d
Access to
SETUP
menu.
e
Welding current;
*The water cooler unit can be enabled only from
the MIG SETUP screen. (see MIG SETUP SCREEN
section)
1) Respect the indications given previously
concerning primary connection and installation.
2) Connect the earth cable to the socket of the
machine. Positive polarity ( + )
3) Connect the torch coupling to the socket of the
machine. Negative polarity ( - )
4) Connect the gas coupling of the torch to the gas
connector in the front of the generator.
5) Connect the gas bottle to the connector
provided on the rear of the generator.
6) With the
Select Mode
button (ref.7) to select the
TIG mode (ref.2)
7) Set the welding current
with the encoder
A/W.Sp.
(ref.13).
8)Proceed with welding.
PREPARING FOR MIG
WELDING WITH GAS
a
Indication of the chosen program;
b
Welding current;
c
Signal of water cooler enabled;
d
Signal of double pulsation enabled;
e
Access to
SIN/MAN
menu;
f
Access to
JOB LIST
menu;
g
Synergic voltage adjustment;
h
Access to
SETUP
menu;
i
Signal of spool-gun torch enabled;
j
Wire speed;
k
Material thickness;
l
Synergic voltage;
1) Respect the indications given previously
concerning primary connection and installation.
2) Connect the earth cable to the socket of the
machine. Negative polarity ( - )
3) Connect the cable that exit from the front of the
machine to the positive socket ( + )
4) Connect the torch coupling to the centralised
euro
socket of the machine. Positive polarity ( + ).
5) Connect the gas cylinder to the proper coupling
provided on the rear panel of the machine, it is
marked with “EURO”.
6) Load the wire, opening the side door and fitting
the bobbin on the reel provided.
WARNING
WELDING WIRE AND DRIVE PARTS FOR THE
FIRST
4
SECONDS
ARE
AT
WELDING
VOLTAGE.
KEEP HANDS AWAY.
Insert the wire in the wire feeder, making it adhere
to the race of the roller (ATTENTION: the roller has
two races because by turning it over it can be used
for another size of wire.Read the paragraph Rolls
Specifications ).
When changing the section of the wire it is
necessary to change the rollers and the current
supply pipe (that is the end part of the torch from
which you can see the wire protruding).
Unscrew the outside end of the torch (nozzle) and
the current supply pipe to facilitate the passage of
the wire.
Unwind the torch cable so that the wire makes the
least possible number of curves .
Insert the plug in a suitable power socket.
Close the pressing roller, switch on the machine
turning the line switch to “ON” position, press the
wire advance button to make the feeding motor run
until the wire comes out of the torch (keep the side
door closed while performing this operation).
