6939500000
16
Lifting by hand:
Lift the machine using the two handles provided
.
Lifting with hoist and strap
Lift the machine by using ONLY both handles as
shown on the picture.
Keep the machine as horizontal as possible
INSTRUCTION FOR
INSECURE POSITIONING
Failure to properly secure the machine can cause
personal injury. If machine is in an insecure
position do not attempt to switch on. Do not put the
machine on an unlevelled surface greater than 10°.
FRONT PANEL DESCRIPTION
1
ELECTRODE led indicating mode
2
TIG LIFT led indicating mode
3
MIG 2T led indicating mode
4
MIG 4T led indicating mode
5
SPOT WELDING led indicating mode
6
MULTI SPOT WELDING led indicating mode
7
SELECT MODE button
8
Function Selection button
9
Function Selection button
10
Function Selection button
11
Function Selection button
12
Encoder for Voltage regulation/ other
Functions
V/SET
;
13
Encoder for Wire Speed / Amps regulation
A/ W.Sp.
PREPARING FOR
ELECTRODE WELDING
a
Welding current;
b
Signal of pulsation enabled;
c
Access to
JOB LIST
menu;
d
Access to
SETUP
menu.
1) Respect the indications given previously
concerning primary connection and installation.
2) Connect the earth cable to the socket of the
machine. Negative polarity ( - )
3) Connect the electrode holder to the socket of
the machine. Positive polarity (+ );
4)
Insert the bare core of the electrode in the gun;
5) Press the
Select Mode
(ref.7) button to select
the ELECTRODE mode, indicated by the
LED
(ref.1);
6) Set the welding current
with the encoder
A/W.Sp.
(ref.13).
7) Proceed with welding.
V.R.D. (SOLO IN MODALITA’ ELETTRODO)
The
initials
V.R.D.
stand
for
VOLTAGE
REDUCTION DEVICE, which is a system for
reducing the no-load voltage (OCV). When the
V.R.D. is installed in a welding machine it reduces
the maximum no-load voltage to a safety voltage
which is normally less than 18V.
- The V.R.D. is used as an additional aid for
operator safety.
- The procedures for safety at work must always be
carried out with attention.
ATTIVAZIONE DEL V.R.D.
1) Switch on the welding machine;
2) Hold down button
Select Mode
(ref.7) for about
4 seconds, then release the button; the led
indicating electrode mode start blinking (ref.1)
(V.R.D. FUNCTION ON Vout
18V). VRD mode remains activated when
switching the machine off and on again.
ESCLUSIONE DEL V.R.D.
1) Switch on the welding machine.;
2) Hold down button
Select Mode
(ref.7)
for
about 4 seconds, then release the button; the led
indicating electrode mode remains lit with a fixed
light (ref.1 (V.R.D. FUNCTION deactivated). VRD
