6939500000
19
START
SPEED
AND
START
TIME
FUNCTIONING ( 2T ALLUMINIUM )
FUNZIONAMENTO HOT START E IBASE ( 4
tempi ALLUMINIO )
PROTECTION FOR
OVERCURRENT
If the welding current is more than 330 Ampere
there is a protection that automatically reduces the
wire speed and the welding parameters.
In the event the wire speed will show in the follow
mode :
-
Lower welding parameters.
-
The wire speed symbol change color.
-
The value of wire speed flashing changing
color.
The operator must set again the wire speed with a
lower parameter compare to the original parameter
that sent in protection the machine.
PAW™
(PRECISION ALUMINIUM WELDING)
New welding process studied by Stel specially for
welding of thin aluminum sheets from 0,8mm to
2mm thick.
PRE-HEAT
For alluminium 8mm thick
is recommended a pre-
heating of the material .
FUNCTION OF STORING AND
LOADING WELDING
PARAMETERS (JOB MODE)
Function active for all welding modes
This function allows you to store and load at any
time all the settings made on the power source. It
is possible to save 30 welding parameters settings)
STORING WELDING SETTINGS
1) Press the button
JOB LIST
(ref.9) to go in the
JOB LIST page.
2) Using the button ↑ (rif.10) ↓ (rif.11) or the
encoder
V/SET
(ref.12) select the number of the
programme in which you want to save the welding
parameters.
3) Press and hold the
SAVE
button (ref.9) for about
3 seconds until you will hear the sound of the
buzzer.
4) When the parameter will be saved you will come
back immediately on the main page and it is
possible see on the frame JOB the JOB number
you are using.
ATTENTION : THE PARAMETERS SAVED FROM
THE POSITION 1 TO 12 ARE PROTECTED; SO
WHEN YOU WILL RECALL THEM , THEY WILL
BE BLOCKED.
TO REMOVE THE PROTECTION OF THE
PARAMETER AND COME OUT FROM ANY JOB
CONDITIONS PRESS THE BUTTON
JOB LIST
(ref.9) TO GO IN THE JOB LIST page AND
PRESS AND HOLD THE BUTTON
SELECT
MODE
(rif.7) FOR ABOUT 5 sec.
LOADING STORED WELDING PROGRAMS
1) Press the button
JOB LIST
(ref.9) to go in the
JOB LIST page.
2) Using the button ↑ (rif.10) ↓ (rif.11) or the
encoder
V/SET
(ref.12) select the number of the
programme that you want recall.
3) Press and hold the
RECALL
button (ref.8)
for about 3 seconds until you will hear the sound of
the buzzer.
4) After the recalling you will come back
immediately on the main page and it is possible
see on the frame JOB the JOB number you are
using.
NOTE :
The symbol “
*
“ ( asterisk ) means the JOB in use.
The symbol “
*
“ ( asterisk flashing ) means the
JOB is modified from the original.
