Installation of a Drawer
Suspension
If a drawer suspension becomes disengaged,
re-install the suspension as follows:
NOTE:
Slides must
NOT
be installed with a
hammer.
1.
For lateral files and combo cabinets:
Locate rear slide tabs into slots (1a). Pull
slide forward (1b). Insert front/top tab into the
slot by twisting slide slightly and pushing
towards the case side (1c). Pull downward
and rotate the bottom/front tab into the
lower/front slot (1d).
2.
For towers and workstation verticals:
a) Insert the rear hook of the slide into the
rear bracket of the pedestal body.
b) For the right hand slide, hook the slide into
the square hole on the front upright of the
pedestal body and
PRESS DOWN
to snap
the slide into position.
TIP:
Pull slide out to gain better leverage.
c) For the left hand side, repeat steps 1 and 2
except you need to
LIFT UP
to snap the slide
into position.
1c
1d
EQUAL
EQUAL
2a
REAR END OF
SUSPENSION
1a
1b
2b
Page 8 of 27
939501617 Rev V
