Ganging Cases Together
1a.
For steel-top cases with knockouts,
use a hammer and punch to remove
ganging knockouts.
1b.
For all other cases, perform step 2
first, then do one of the following:
1. Drill 9/32" holes in case body
to use the supplied ganging kit.
2. Drill 3/32" holes in case body
to use #8 sheet metal screws.
3. Mark locations in case body
if using #8 self-drilling screws.
2.
Align cases and slide together. Ensure all cases
are level and square to ensure proper hole alignment.
Secure cases together using the appropriate
fasteners through the ganging holes.
3a.
Steel-top versions with supplied
ganging kit (1/4-20 nuts and bolts).
3b.
All other versions with either:
(This includes 42" wide top
locking units)
1. 1/4-20 nuts and bolts
2. #8 sheet metal screws
3. #8 self-drilling screws
2
1b
3a
Wood Version
3a
Page 12 of 27
939501617 Rev V
1a
Underside of Lockers
4a
4b
Ganging Bottom of
Lockers Together
Gang lockers together per steps 1
through 3 on this page.
4a.
Remove inner glides as shown.
4b.
Install ganging plate with flat
head screws.
Maximum combined locker ganging
width is 36".
ALL SINGLE WIDE LOCKERS
NEED TO BE EITHER GANGED
OR MOUNTED.
Y565852 rev E
DO NOT:
You MUST:
WARNING
TIP OVER
HAZARD
Install this unit against a wall or gang
to a similar unit.
FOLLOW THESE INSTRUCTIONS TO
PREVENT UNIT FROM TIPPING OVER AND
CAUSING INJURY.
See Assembly Directions for further
instruction, available from Steelcase
dealer or call 1-888-783-3522
Pull down on doors (if equipped)
Move unit or adjust glides if loaded
