55 of 86
9.1.4 Analog outputs 1 to 4
Figure 1: Analog outputs 1 to 4
Output signal type (Ax.Mod)
This function defines how the output is operated (see Figure 1 Pos. 5). Current
and voltage outputs are possible. Depending on the receiver type, two or four
analog outputs are available.
Chapter 2.2 "Type designation"
Output value (Ax.SEL)
The process value to be put out at the selected output is defined here (see Figure
1 Pos. 6). In addition to the process values of the 16 wireless inputs, four Modbus
remote control values are available in the analog selector.
Zero point (Ax.Zer) and end point (Ax.End)
The zero point and the end point (see Figure 1, Pos. 3 and Pos. 4) permit the
entire measuring range or part of it to be displayed at the output (e.g. (0 to 200)
°C).
Error behavior (Ax.Err)
The type of error message to become active under the following conditions is set
here (see Figure 1 Pos. 7):
•
overrange/underrange
•
Probe short circuit
•
Probe break/wire break and
•
Alarms
Summary of Contents for WRX900 Series
