5
Science First
®
/
STARLAB
®
• 86475 Gene Lasserre Blvd, Yulee, FL 32097 USA
800-875-3214 • 904-225-5558 • FAX 904-225-2228 • www.starlab.com
Figure 3
Figure 4
1. Lay the Digital
STARLAB
®
case flat on its
bumpers so that the telescoping handle is near
and parallel to the floor.
2. Open the case by pulling out and turning the
keys to disengage the four latches located two
on each long side of the case. To do so, pull
the key up and turn to the left. Once all of the
latches are disengaged, make sure to lay them
flat again.
3. Place the top (lid) of the case (the smaller
section) on the floor with the foam side down
in the center of the dome. This is the base of
the stand (see Figure 1).
4. Next, remove all of the components from the
bottom of the case starting with the projector.
Lift the projector from the sides where there
are spaces in the foam (see Figure 2). Place
it on a stable surface. Then remove all other
components including the computer, two
speakers, cables and remote.
5. Once empty, flip the case bottom onto its side
so that the small latch hook on each long end
is parallel to and near the floor.
6. In this position, place the bottom section of
the case onto the top section (see Figure 3)
so that the wheel side of the bottom section
and the bumper side of the top section are
on the same end. Align the latch hook with
the latches (see Figure 4). Make sure that the
latches are securely fastened and laid flat.
Figure 1
Digital
STARLAB
®
Cables and accessories
Computer
Lift From Here
Lift From Here
Speakers
Set-Up Instructions
Figure 2
