2.The schedule backup that it is really not to appoint other device as rebuilding data to
the internal RAID system,but to rebuild the data in the RAID system by itself at
regular time.
※
How to change the function from Schedule Backup to RAID 1 mode
1. Please enter to the ”SCHEDULE BACKUP” operation mode on the LCD screen
again.
2. Please adjust the time days to become "00" and make sure them input the system
under Schedule Backup operation mode.(As The next screen appears
with ”SCHEDULE BACKUP TIME 1->30 (DAYS) 00”, please following the
service manual chapter 3-3 )
2.If you finish the above steps, please restart the power of SR3610 to ensure the days
parameters are embedded then RAID 1 will be enabled.
Note.
1.The parameters had been embedded under SR3610, please should be restart the
Power to ensure the setting is enable.
2.Complete the above procedure and restart the power, the system will become
the RAID 1 mode. If you want to change from RAID 1 to RAID 0, please refer
to the service manual chapter 3-2
-
21
-
