§ Setting up RAID 0
In the event you’d like to install one new hard-disk and one already used hard-disk, it
is advisable to select the new hard-disk to be the same as the used one in terms of
brand, size, and storage capacity.
．
Operation mode button RAID 0(Refer Chapter 3-2 to set up)
Turn off the power of computer and install 2 pcs of hard disks into carries
of SR3610.If the RAID 0 mode already had been set up and then restart turn on the
power of computer, it will show capcities of storage under device manager.
Please assign this RAID disk under disk management and then click right of mouse
button to run partition.
Notices:
1. In case it is necessary to turn off the power of SR3610 or disconnect its USB 2.0
connection cable, please stop the usage or exit of above items in the computer
system. (Hardware icons are displayed
at the lower right-hand corner on Windows
desktop.)
2. During RAID 0 operation mode, in the event of one hard-disk fails, the all data will
be lost.
3. RAID 0 and RAID 1 can not be used simultaneously, only one could be selected .
4. Attention! In case you wan to switch operation mode from RAID 0 to RAID 1,
please backup date and remove it in advance, otherwise, the original date will be
lost.
5. RAID 0 will automatically detect the hard-disk with the smaller storage capacity of
the two, if one is larger than the other in terms of capacity, it will assign storage
space base on the hard-disk with smaller capacity, and combine the storage space of
the two to become storage capacity of one hard-disk.
(In other words, the smaller capacity multiplies by 2 to be considered one
programmable logic array.)
-
16
-
