Star Headlight & Lantern LCS850MG, Installation And Instruction Manual

Page: 25 / 64

-22-
Installation: Detailed Programming
Steady or Pulsed Output Options
If you have set any of the outputs to pulse (as described above), they will default to a slow
flashing pattern. If you would like your pulsed outputs to use a fast flashing pattern,
change this setting. All pulsed outputs must be slow or all pulsed outputs must be fast.
You cannot program the pulse speed of each output independently.
Button is Green : (Default setting) ALL pulsed outputs will flash slow.
Button is Red : ALL pulsed outputs will flash fast.
If you have set any of the outputs to pulse (as described above), there are two “phases”
each can flash in (Phase 1 alternates with Phase 2). By default, all of the outputs are set
for Phase 1 (they will all flash “On” at the same time). If you wish any of the outputs to
flash in Phase 2 (opposite Phase 1), change this setting.
Button is Green : (Default setting) Output, if pulsed, will flash during Phase 1.
Button is Red : Output, if pulsed, will flash during Phase 2.
A
d
v
a
n
c
e
d
P
u
ls
e
d
O
u
tp
u
t
P
ro
g
ra
m
m
in
g
The outputs switched by each push button normally apply 12 VDC.
If you would like any of these outputs to be flashing or pulsed (i.e. if you were hooking it up to
a light that didn’t have its own flasher), change this setting.
Button is Green : (Default setting) The output will deliver 12 VDC.
Button is Red : The output will pulse +12 VDC.
Each button ( PB1-PB5, PB13, PB14 ) can be programmed independently of the others. The
buttons that control any outputs programmed to flash, will flash green to indicate they are a
“pulsed” output.
Once you have programmed all necessary options, you must flip
the Programming Mode DIP switch down to save the changes.
Once you have programmed all necessary options, you must flip
the Programming Mode DIP switch down to save the changes.
Once you have programmed all necessary options, you must flip
the Programming Mode DIP switch down to save the changes.
Pulsed Output Rate
Pulsed Output Phase (for use with two or more pulsed outputs)
Steady or Flashing/Pulsed Outputs
Programming Mode DIP Switch: Up
Slide Switch: Off
Activate this button (RED): YELP
And modify any of these buttons: PB1-PB5, PB13, PB14
Programming Mode DIP Switch: Up
Slide Switch: OFF
Audio Mode Buttons (HF/WAIL/YELP/PHSR/RADIO): All OFF/Green
And modify this button: PB1
Programming Mode DIP Switch: Up
Slide Switch:
1
1 1
1
Activate this button (RED):: YELP
And modify any of these buttons: PB1-PB5, PB13, PB14