Star Headlight & Lantern LCS850MG, Installation And Instruction Manual

Page: 17 / 64

-14-
Detailed Programming Summary Table
The options below should be programmed PRIOR to installation of your siren.
Refer to pages 15-34 for detailed programming instructions.
Installation: Detailed Programming
Detailed Programming Summary Table
Option Default Setting Optional Setting PG
Button Operation
(Open or Closed) Activating a Button (Turning it on) Will
Apply +12VDC (Closed)
Activating Button (Turning it on) Opens
The Circuit (Off/Not Connected)
17
Push Button State at Power Up PB5 On (if enabled by DIP switch 9) Any Can Be On at Power Up
Button Operation
(Latched or Momentary)
All are Standard On/Off (Latched) Any Can Be Momentary
18
Auto Beep When Any Function
Active
Disabled Beeps Every 10 sec.
WARN Pattern Excluded From TD
Pattern Cycle Button
WARN Pattern Included No WARN Pattern in TD Cycle
Gun Lock Timer Button Assignment Button PB14 None, PB1, PB2, PB3, PB4, PB5, PB13
19
Gun Lock Timer Period 10 Seconds 20 Seconds
Gun Lock Pass Code Enable No Passcode Needed Passcode Need to Unlock Gun 20
Setting the Gun Lock Pass Code PB1, PB3, PB5 Any Buttons (PB1-PB5)
21
Radio/PA Speaker Diagnostic POP Radio and PA send POP signal No POP
Steady or Flashing/Pulsed Outputs All Steady Output Any Can Be Pulsed
22 Pulsed Output Rate Slow Fast
Pulsed Output Phase All Buttons Phase 1 Any Button(s) Phase 2
Manual "Step Up" Function Time Out Never Times Out Times Out After 15 sec.
23
Manual Wind Down Function
MAN Tone Winds Down When MAN
Button Released
MAN Tone Stops Immediately When
MAN Button Released
Siren Disable—Only PA & Air Horn
Function
Siren Enabled Siren Disabled
24
Audio Lockout Disabled
All Audio Functions Locked Out Until
Button(s) or Slide Switch Programmed
Audio Lockout Unless Select If Enabled, Slide Positions 1, 2, and 3 Any Output(s)
Audio Pursuit Options WAIL in Slide Position 3 Any Tone In Any SS Position or Any PB 25
Audio Pursuit Mode (HF or WAIL) WAIL mode activated in pursuit HF mode activated in pursuit
26 HF Mode at Boot No Mode Active at Power Up Siren In HF Mode at Power Up
Quick Shot Tone Replaces Air Horn Air Horn Quick Shot Tone When Air Horn Pressed
Second Tone Swap in Magnum
Mode 2nd Tone of Magnum Mode Stepped
Up in SS3
2nd Tone of Magnum Mode Staggered
Clone of First Tone in SS3
27
Tones Sweep Disable in HF for Slide
Switch Position 3
Tones Sweep in HF Mode and SS3 if Sweep
Feature Enabled by DIP
Tones Do Not Sweep in HF Mode and
SS 3
28
High-Low Override of Phaser Tone
Phaser Tone When PHSR Button
Pressed
High-Low Tone When PHSR Button
Pressed
Horn Ring Transfer Active Mode
Always Active - Vehicle Horn (HRT)
Will Always Control Siren
Vehicle Horn (HRT) Will Only Control
Siren If Programmed Button(s) are ON
or Slide Switch is in Programmed
Position(s)
29
Button(s) or Slide Switch Required For
HRT to Activate
If Enabled, SS1, SS2, and SS3
Add Any Button(s) or Remove Any Slide
Switch Positions
Slide Switch Programming (if
enabled)
None
Any Button or SS output Can Be
Activated By Any SS Position
30
Slide Switch Options Auto-Off Enabled Disabled
31
Traffic Director Visual Pursuit Option TD WARN Auto-Activates in SS3 Enable or Disable Any Positions
Logic Controlled TD Output Select 3-Wire LOGIC + Power 3-Wire Independent or 2-Wire+Power
32
TD Logic Polarity Positive Switching Negative Switching
Function When Ground Applied to
Optional Input 1
Dim Backlighting Gun Lock
33
Function When +12VDC Applied to
Optional Input 2
Gun Lock Dim Backlighting
Park-Kill De-activation Of Lights Park-Kill only Disables Siren
Park-Kill Disables Both Siren AND any
selected outputs
34
Reset To Defaults Disabled Reset Siren to Factory Default Settings