Star Headlight & Lantern LCS850MG, Installation And Instruction Manual

Page: 23 / 64

-20-
Installation: Detailed Programming
Gun Lock Pass Code Enable
This feature can ONLY be used if your Gun Lock release button is PB14 .
Normally the Gun Lock can be operated by simply pressing the appropriate Gun Lock button.
If you require a higher level of security, you can require a Pass Code to be entered to release
the Gun Lock
( PB14 only) .
To require that the pass code, change this setting:
Button is Green : (Default setting) No Pass Code required to release Gun Lock.
Button is Red : Pass Code required to release Gun Lock.
Under normal operation, if you have the Pass Code option enabled, when the PB14 Gun Lock
button is pressed:
 The Gun Lock button will turn a flickering red/green.

Buttons PB1-PB5 will all turn green.
 The siren and lighting functions selected before the Gun Lock button was pressed will
remain active but unable to be changed until the Gun Lock pass code entry is
complete.
To release the Gun Lock:
 While the Gun Lock button is flickering Red/Green, press the appropriate buttons ( P1-
P5 ). ONLY the designated buttons can be “ON” (RED). The default pass code is
buttons 1, 3, and 5 ON/RED and buttons 2 and 4 OFF/GREEN.
 Then press the Gun Lock button again (or wait 10 seconds until time out occurs).

If the correct pass code was entered (correct buttons are RED) the Gun Lock will
temporarily release and the other functions on the siren will be editable once again.

If the incorrect password was entered, the siren will beep 5 times quickly and the Gun
Lock WILL NOT be released.
Default Pass Code
PB1 ON Red
PB2 OFF Green
PB3 ON Red
PB4 OFF Green
PB5 ON Red
Once you have programmed all necessary options, you must flip
the Programming Mode DIP switch down to save the changes.
Gun Lock Button Pass Code Enable
Programming Mode DIP switch: Up
Slide Switch:
2 2 2 2
Modify this button: PB5
All of the options on pages 17
All of the options on pages 17 All of the options on pages 17
All of the options on pages 17----34 can optionally be programmed using free software and a
34 can optionally be programmed using free software and a 34 can optionally be programmed using free software and a
34 can optionally be programmed using free software and a
USB to serial cable (P/N SUSB USB to serial cable (P/N SUSB USB to serial cable (P/N SUSB USB to serial cable (P/N SUSB----850MG) available upon request from StarSignal at 585 850MG) available upon request from StarSignal at 585 850MG) available upon request from StarSignal at 585 850MG) available upon request from StarSignal at 585----226 226 226 226----9787. 9787. 9787. 9787.