Stanley SBD20, Original Instructions Manual

Page: 6 / 48

• Never attempt to charge non-rechargeable batteries.
• Have defective cords replaced immediately.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
The charger is intended for indoor use only.
Read the instruction manual before use.
LABELS ON TOOL
The following symbols are shown on the tool along with the
date code:
WARNING! To reduce the risk of injury, the user must
read the instruction manual.
Always wear safety goggles
Always wear safety hearing protection
Position of date code
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:
2017 XX JN
Year of manufacturing
PACKAGE CONTENTS
The package contains:
1 Drill/driver
1 Charger
2 Batteries (C2/S2/D2/M2) or 1 Battery (C1/S1/D1/M1)
1 Instruction manual
• Check for damage to the tool, parts or accessories which
may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
FEATURES (Fig A)
This appliance includes some or all of the following features.
1. Trigger Switch
2. Forward/Reverse Button
3. Torque Adjust Collar
4. Dual Range Gear Selector
5. Keyless Chuck
6. Battery
7. Battery Release Button
8. LED Work Light
9. Bit Tip Holder
USE
WARNING! Let the tool work at its own pace. Do not overload.
CHARGING THE BATTERY
The battery needs to be charged before first use and whenever
it fails to produce sufficient power on jobs that were easily done
before. The battery may become warm while charging; this is
normal and does not indicate a problem.
WARNING! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tempera-
ture: approx. 24 °C
NOTE: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger will
begin to charge automatically when the cell temperature warms
up or cools down.
• Plug the charger into an appropriate outlet before inserting
the battery pack.
• Insert the battery pack into the charger.
The green LED will flash indicating that the
battery is being charged.
The completion of charge is indicated by the
green LED remaining on continuously.
The pack is fully charged and may be used at this time or left in
the charger..
WARNING! Recharge discharged batteries as soon as
possible after use or battery life may be greatly diminished.
Charger diagnostics
This charger is designed to detect certain problems that can
arise with the battery packs or the power source. Problems are
indicated by one LED flashing in different patterns.
Bad battery
The charger can detect a weak or damaged
battery. The red LED flashes in the pattern
indicated on the label. If you see this bad
battery blink pattern, do not continue to
charge the battery. Return it to a service
centre or a collection site for recyclin
Hot/cold pack delay
When the charger detects a battery that is
excessively hot or excessively cold, it
automatically starts a Hot/Cold Pack delay,
suspending charging until the battery has
normalised. After this happens, the charger
automatically switches to the Pack Charging
mode. This feature ensures maximum
battery life. The red LED flashes in the
pattern indicated on the label when the
Hot/Cold pack delay is detected.
Problem power line
When the charger is used with some
portable power sources such as generators
or sources that convert DC to AC, the
charger may temporarily suspend operation.
The LED flashes in the pattern indicated on
the label. This indicates that the power
source is out of limits..
ENGLISH
(Original instructions)
6