Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
Preparing the door and door jamb
4
1
Position template and mark drill points
Note: If the door is a fabricated hollow metal door,
determine whether it is properly reinforced to support
the lock. If door reinforcement is not adequate, consult
the door manufacturer for information on proper
reinforcement. For dimensions for preparing metal
doors, see the W14 Template—Installation
Specifications for 83KM/93KM–85KM/95KM IDH Max
Cylindrical Locks.
Note: If the door is a LH or RH door, mark the inside of
the door. If the door is a LHRB or RHRB door, mark the
outside of the door.
For uncut doors and frames
1 Measure and mark the horizontal centerline of the
knob/lever (the centerline for the chassis hole) on the
door and door jamb. Mark the vertical centerline of the
door edge.
Note: The recommended height from the floor to the
centerline of the lock is 38
″
.
2 Fold the
W16 Template—Installation Template for
83KM/93KM IDH Max Cylindrical Locks
on the dashed
line and carefully place it in position on the high side
of the door bevel.
Note: For steel frame applications, align the template’s
horizontal centerline for the latch with the horizontal
centerline of the frame’s strike preparation.
3 Tape the template to the door.
4 Center punch the necessary drill points. Refer to the
instructions on the template.
For doors with standard cylindrical preparation
1 Fold
the
W16 Template—Installation Template for
83KM/93KM IDH Max Cylindrical Locks
on the dashed
line. Looking through the hole from the opposite side
of the door, align the template so that you see the
template outline of the 2 1/8
″
diameter hole.
2 Tape the template to the door.
3 Center punch the necessary drill points. Refer to the
instructions on the template.
Figure 1
Positioning the template
Installation template
Horizontal centerline
of lock
