Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
Troubleshooting the installation
24
To troubleshoot installation problems, refer to the table
below. For more information, refer to the
W Series Service
Manual
(T60775) and to the documentation provided by
the manufacturer of the access control panel/reader
interface.
You notice . . .
Possible causes include . . .
You should . . .
Control electronics’ green status
LED and panel interface module’s
green status LED are steadily on.
Note:
You can check the control
electronic’s green status LED by
removing the access door from the
inside trim. You can see the
reflection of the LED inside the
upper-left corner of the trim.
Communication between the lock’s
control electronics circuit board and the
panel interface circuit board has been
interrupted.
Make sure DIP switches 6 and 7 on the lock’s
control electronics circuit board are both set to ON
(automatic baud rate detection) or to the same
positions as DIP switches 2 and 3 on the panel
interface circuit board.
Check the connections for all communication field
wiring.
Check the communication connections between
the field wire harness and the wire transfer hinge.
Control electronics’ green status
LED is off.
Power is not being supplied to the lock.
Make sure that the lock’s power supply is
connected to electrical service.
Check the connections for all power field wiring to
the lock.
Check the power connections between the field
wire harness and the wire transfer hinge.
Panel interface module’s green
status LED is off.
Power is not being supplied to the panel
interface module.
Check the connections for power wiring between
the panel interface module and the access control
panel (or other power source).
A ‘door forced’ alarm occurs when
someone exits through the door.
RQE wiring and door status wiring is
reversed between the panel interface
module and the access control panel/
reader interface.
Refer to
Connect panel interface module to access
control panel/reader interface,
on page 19, and
correct the wiring problem.
© 2002–09 Stanley Security Solutions, Inc
T61842/Rev D 1852379 ER-7991-12 Dec 2009
