Standart Horizont GX2000, Owner'S Manual

Page: 68 / 136

GX2000/GX2100 Page 68
11.8.2 Setting up a Position Request Ringer
The GX2000/GX2100 has the capability to turn off the Position Request ringer.
1. Press and hold down the [ CALL
(
MENU
)] key
until “ Setup Menu ” appears.
2. Rotate the CHANNEL knob to select “
DSC
SETUP
” menu.
3. Press the [ SELECT
] soft key, then select “
DSC
BEEP
” with the CHANNEL knob.
4. Press the [ SELECT
] soft key, then select “
POS
Request ” with the CHANNEL knob.
5. Press the [ ENT
] soft key, then select “
Off
” with
the CHANNEL knob.
6. Press the [ ENT
] soft key to store the selected set-
ting.
7. Press the [ QUIT
] soft key several times to return to radio operation.
To re-enable the ringer tone, repeat the above procedure, rotating the CHAN-
NEL knob to select “
On
” in step “5” above.
11.8.3 Transmitting a Position Request to Another Vessel
Pre-Programmed Request
1. Press the [ CALL
(
MENU
)] key. The “
DSC
Menu
” will appear.
2. Rotate the CHANNEL knob to select “ POS RE-
QUEST
”.
3. Rotate the CHANNEL knob to select a name
that was stored in the Individual DSC direc-
tory, then press the [
SELECT
] soft key.
4. Press the [ YES
] soft key to transmit the Posi-
tion Request DSC call.
5. When the GX2000/GX2100 receives the position
from the polled vessel it is shown on the ra-
dio display and also transferred to a GPS
Chart plotter with NMEA DSC and DSE sen-
tences.
6. Press the [ QUIT
] soft key to return to radio opera-
tion.
NOTE
If the GX2000S/GX2100S does not receive a position data from the
polled vessel, the display will show “NO POSITION DATA.”