STEP 1
The
FRONT STABILIZER(4)
has two
MOVING WHEELS(48)
with an
"R"
decal on one end. Attach the
FRONT STABILIZER(4)
to the
MAIN FRAME(1)
with the wheels facing front and the
"R"
decal at the right
side as shown in the illustration. Secure with the
CARRIAGE BOLTS(M8x1.25x60mm)(56), ARC
WASHERS(M8)(74),
and
ACORN NUTS(M8x1.25)(69).
STEP 2
Attach the
REAR STABILIZER(3)
to the
REAR FRAME(2)
with
CARRIAGE BOLTS(M8x1.25x60mm)(56),
ARC WASHERS(M8)(74),
and
ACORN NUTS(M8x1.25)(69).
NOTE:
R
6
ASSEMBLY INSTRUCTIONS
You can adjust the
LEVELING CAPS(50)
on the
REAR STABILIZER(3)
to keep the
INTONE
Folding Recumbent Bike
stable.
Nylock Nut(M8)
Plastic Washer
Fixing Tube
NOTE: Remove the FIXING TUBES, WASHERS, and NUTS from MAIN FRAME(1) and REAR FRAME(2)
before any assembly. These parts are only for packing, do not dispose of the packing materials
until assembly is completed.
STEP 3
Store the
PULL PIN(47)
by inserting the pin into the hole in the
REAR FRAME(2).
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please call
our toll-free number for assistance 1-800-375-7520 or e-mail us at [email protected].