ASSEMBLY INSTRUCTIONS
8
STEP 7
NOTE:
Thread the
RIGHT PEDAL(40)
onto the right side of the
CRANK(8).
Thread the
LEFT PEDAL(39)
onto the
left side of the
CRANK(8).
STEP 8
Refer to the illustration. Swing the
METER BRACKET(31)
up to a position where it can be seen while
working out.
NOTE:
If necessary, loosen or tighten the
HEX BOLT(M8x1.25x55mm)(66).
The
HEX
BOLT(M8x1.25x55mm)(66)
should be tight enough to secure and hold the
METER(32)
in place yet loose
enough for the
METER(32)
to be adjusted.
Install two
AA
batteries into the
METER(32),
two batteries included. See page 10 for detailed battery
installation instructions. Run the connection wire on the
METER(32)
through the hole in the
METER
BRACKET(31).
Then attach the
METER(32)
to the
METER BRACKET(31)
with
ROUND HEAD
SCREWS(M5x0.8x10mm)(60).
Plug the
SENSOR WIRE(33)
into the connection wire of the
METER(32).
The
RIGHT PEDAL(40)
has
R
stamped on the end of the pedal shaft. The
RIGHT PEDAL(40)
has
right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(39)
has
L
stamped on
the end of the pedal shaft. The
LEFT PEDAL(39)
has left hand threads and is tightened by turning
counter clockwise.