STORAGE
To store the
INTONE Folding Recumbent Bike
simply keep it in a clean dry place.
The minimum folded dimensions of
INTONE Folding Recumbent Bike
are approximately 21 5/8" long
x 25 3/8" wide x 42 1/4" tall. Please measure your
INTONE Folding Recumbent Bike
if exact dimensions
are needed.
The
INTONE Folding Recumbent Bike
has a pair of
MOVING WHEELS(48)
built into the
FRONT
STABILIZER(4).
To move the bike, grasp the
HANDRAIL(7),
tip the
INTONE Folding Recumbent
Bike
forward slowly, and roll into or out of the storage area.
To avoid damage to the
METER(32),
remove the batteries before storing the
INTONE Folding
Recumbent Bike
for one year or more.
Follow the illustrated process below to fold the
INTONE Folding Recumbent Bike.
1.
2.
3.
4.
5.
Loosen the
LOCKING KNOB(45).
Lift up the
BACK SUPPORT(6)
and fold it forward. Tighten the
LOCKING KNOB(45)
after folding.
Remove the
PULL PIN(47)
from the
REAR FRAME(2).
Fold the
REAR FRAME(2)
close to the
MAIN
FRAME(1)
and lock it in folded position with the
PULL PIN(47).
NOTE:
B
12
D
A
C
Loosen and pull the
ADJUSTMENT KNOB(41),
then lower the
SEAT FRAME(5)
to the lowest position.
Lock the
SEAT FRAME(5)
into position by releasing and retightening the
ADJUSTMENT KNOB(41).
Swing the
METER(32)
down toward the floor as shown in illustration D.
a.
b.
Make sure the
LOCKING PIN(47)
goes through the holes on both sides of the
REAR FRAME(2)
and the ring on the
MAIN FRAME(1).
NOTE:
c.
When you fold the
INTONE Folding Recumbent Bike
without changing the seat height or the
angle of the
METER(32)
as described in the steps above and as shown in illustration C, there is
no need to readjust your seat height or meter angle before your next workout. You can fold your
INTONE Folding Recumbent Bike
smaller by following the next step.