ASSEMBLY INSTRUCTIONS
11
Rubber Pad
( 9 pieces)
Bolt End
Bolt End
6.
7.
A
C
D
B
STEP 14:
Have one person pull up the two
GUIDE TUBES(7)
on the right side to the position higher than
the
SELECTOR ROD(8)
on left side and hold them. Stack nine
WEIGH PLATES(40)
onto the
WEIGHT
PLATE SUPPORT(4)
with the Rubber Pad side down. Refer to detail view 6. Slide the
GUIDE TUBES(7)
down through all of the
WEIGHT PLATES(40)
. Make sure the
GUIDE TUBES(7)
are all the way down to
the
MAIN BASE(1)
.
STEP 15:
Refer to detail view 6. Insert the
BUNGEE CORD(42)
through all of the
WEIGHT PLATES(40)
and hook to the Bolt End of the
ROPE(212)
. Pull the
ROPE(212)
up through the
WEIGHT PLATES(40)
with
the
BUNGEE CORD(42)
. Refer to detail view 7. Screw the Bolt End of the
ROPE(212)
into the bottom end
of the
SELECTOR ROD(8)
. Disconnect the
ROPE(211)
from the
RIGHT LOWER SWIVEL BRACE(17)
.
NOTE:
Hold the
ROPE(212)
at the position right next to its Bolt End, so the
ROPE(212)
will not rotate
when screwing the Bolt End into the
SELECTOR ROD(8).
STEP 16:
Refer to the main tower illustration. Route the
ROPE(212)
around the
PULLEY(203)
that is
located below the weight stack
(A)
and also around the
PULLEY(202)
that is located at the base of the
UPRIGHT
FRAME(11)(B).
Connect the
ROPE(212)
to the
BUNGEE CORD(42).
Route the
BUNGEE
CORD(42)
around the upper
PULLEY(202)
at (
C).
Pull the
BUNGEE CORD(42)
down and connect to the
hook on the
UPRIGHT FRAME(11)
at (
D).
Repeat STEP 10 to STEP 16 to assemble
the
WEIGHT PLATES(40)
on other side.
Summary of Contents for 55-6510A
Page 28: ...PRODUCT PARTS DRAWING 28 BACK...
Page 29: ...29 FRONT...
Page 36: ...NOTES 36...
Page 37: ...NOTES 37...
