With this function, the scene in the current edit point is removed from a chaser
sequence.
1.
To enter ‘Program Mode’, keep
[Program]
pressed for three seconds.
2.
Press the
[CHASER]
of that chaser sequence you want to edit. You can only edit
one chaser sequence at a time.
If you select a chaser sequence that already contains scenes the edit
point automatically jumps to the end of the chaser sequence.
3.
Press
[Tap Sync Manual Go]
.
ð
The display shows the current edit point.
4.
Use |
[Up]
or |
[Down]
to select the desired edit point.
5.
Press
[DELETE]
.
ð
The LED flashes three times briefly.
This indicates that the scene has been removed successfully.
All scenes that have been lying behind the removed scene, slip
one position forward. If you press, for example, three times
[DELETE], the three scenes after the initial edit point are removed.
6.
To return to ‘Play Mode’, keep
[Program]
pressed for three seconds.
With this function, a chaser sequence is deleted, i.e., all the scenes are removed from
it.
1.
To enter ‘Program Mode’, keep
[Program]
pressed for three seconds.
2.
Keep pressed
[DELETE]
.
3.
Then press the
[CHASER]
button of the sequence you want to delete.
ð
The LED flashes three times briefly.
This indicates that all scenes have been removed successfully from the
chaser sequence.
4.
To return to ‘Play Mode’, keep
[Program]
pressed for three seconds.
With this function, all chaser sequences are deleted, i.e., all the scenes are removed
from them.
1.
Ensure that the device is switched on.
2.
Simultaneously press |
[Up]
and |
[Down]
and switch the device off.
3.
Keep the buttons pushed and turn the device back on.
ð
All LEDs will flash three times briefly.
Removing scene from a chaser
sequence
Deleting a chaser sequence
Deleting all chaser sequences
Instructions for use
DMX controller
24
