18
DMX Control Operation ..................................................................
1.
Use the function button under the LCD display to set up the DMX channel
mode and DMX address (Figure 1-G). There are 3 DMX modes for choice;
1CH, 4CH, & 6CH DMX mode;
4.
Connect the DMX 512 controller cable to the input socket (Figure 1-J or L)
of the machine unit. Make sure the signal cable polarity is correct.
When DMX socket receives effective DMX signals, the machine enter DMX
control mode automatically;
6.
After entering the DMX operation mode (receiving DMX signal and starting
work), DMX channel mode can still be switched at this time, but must use
Function button to do channel mode switching. At the same time, we can
use UP/DOWN button to change the DMX address values;
Press Function button to enter DMX mode setting,
press UP/DOWN button to select the channel mode,
there are 1CH, 4CH, and 6CH to choose from,
set values are automatically saved. Left display
shows 6 channel mode;
Set values are automatically saved. Then enter the
DMX operation state, the two bars next to the state
will start to blink.
LCD display of machine description:
The first line shows the state, there will be 4 states
HEATING, RUNNING, CLEANING and STANDBY;
The second line shows the current state of smoke
output is 80%, state of wind volume is 30%, and
water mist volume is A+B setting at DMX console.
If 6CH mode, the second line shows the current
state of smoke output is 80%, duration is 27s, and
interval is 30s setting at DMX console;
Press Function button to enter DMX address setting,
press UP/DOWN button to adjust DMX address ,
When the desired address value is set, the DMX
address is automatically saved. Left display shows
the DMX address is 1;
DMX MODE
6 CH
— —RUNNING— —
F80 W30 U: A+B
— —RUNNING— —
F80 D27 I30
DMX ADDR
1
2.
5.
3.
