05
This device provides the possibility to choose one of the following operating logics for the command buttons :
“Pulse” logic
This is the default mode from the factory. The motor moves up (down) if the relevant contact is closed on phase for at least 0.5 sec, the motor will stop if any one
of the two contacts is closed briefly (less than 0.5 sec).
“Hold to run” logic
The motor moves up (down) if the relevant contact is closed on phase for at least 0.5 sec, the motor stops when contact is open.
06. OPERATING LOGIC OF COMMAND BUTTONS
Bring motor in a
intermediate position
A
05. HOW TO MEMORIZE THE FIRST HANDHELD TRANSMITTER
ON
Give power to the device
P1
Press P1 for some seconds until the 3 LEDs light on
Motor makes 2 upward movements
Motor makes 1 brief upward
movements
Within 15 sec. press STOP
of the transmitter you want
to memorize.
A
B
C
E
D
2x
1x
Note:
ü
(1): if the button is not pressed within 15 seconds, the motor exits the programming and signals it with 2 downward movements
ü
If you have installed the control buttons, you can store the transmitter through the procedure called "Memorization / Deletion of a transmitter via command
buttons»
ü
The memorization of additional transmitters can be carried out in the same way or, more conveniently, by using a portable transmitter already memorized or
the command buttons (see section "Memorization/Deletion of a transmitter")
(1)
STOP
01. Select the correct radio channel and bring the
motor on the intermediate position.
02. Press
MENU
for about 5 seconds.
rS
appears
on the display.
03. Press 1 time
PREV
and 8 times
NEXT
. 18
appears on the display
04. Press 1 time
STOP
. The receiver signals the
current value.
Hold to run:
p
1
(1 short upward movement)
Pulse:
q
1
(1 short descent movement)
05. Press
PREV
for logic «pulse» (
Of
appears on
the display) or
NEXT
for logic «hold to run»
(
On
appears on the display). Factory set is Of.
06. Press 1 time
STOP
. The receiver signal the
new value.
Hold to run:
p
1 - Pulse:
q
1
B.1
B.2
01. Bring the motor to the intermediate position. .
02. While press STOP also press PROG for until the LED
lights up.
03. Press once on UP and 8 times DOWN.
04. Press once on
STOP
.
The motor shows the current value.
Hold to run:
p
1
(1 short upward movement)
Pulse:
q
1
(1 short descent movement)
05. Press
DOWN
for logic «pulse» or
UP
for logic «hold
to run»
06. Press 1 time
STOP
. The receiver signal the new
value.
Hold to run:
p
1 - Pulse:
q
1
USING AN HAND-HELD TRANSMITTER Mod.594
USING AN HAND-HELD TRANSMITTER Mod.593
