FirstLine UPS
Form No. 003-2323 Rev B
8
Remove and discard
1/4" bolt and washers
(4) places
Remove and discard
1/4" bolt and washers
(4) places
Pull (2) shipping brackets
away from cabinet.
Loosen (3) 1/2" nuts on each bracket
Remove (4) 1/4" bolts.
Reinstall after the unit is on the floor
Remove (4) 1/4" bolts.
Reinstall after the unit is on the floor
Figure 3-Shipping Bracket
4.
Remove the front cover (see Figure 9) before inserting the lifting forks.
5.
Ensure that the four (4) leveling feet are raised so that they will not touch the floor
when the cabinet is placed on the floor.
6.
Lift the cabinet with a forklift from the rear of the unit, one to two inches (1”-2” [2.5-
5cm]) above the pallet (see figure 5).
7.
Slide the pallet completely away from the raised cabinet.
8.
Slowly lower the cabinet to the floor or other appropriate flat service.
9.
Reinstall the front cover and add (4) ¼” bolts and washers (see figure 3).
10.
Roll the cabinet to the desired location
11.
Do not move the cabinet to another location by forklift , as the cabinets are heavy
and may fall.
DO NOT ALLOW THE FORKLIFT TO MOVE WHILE THE CABINET IS
RAISED, ONLY MOVE THE CABINET VERTICALLY TO REMOVE THE
PALLET FROM UNDER THE CABINET.
Summary of Contents for FirstLine
Page 43: ......
