Chapter3.
Installation
Stack Pro DVR Users Guide
5
Now identify a suitable location for the Pro DVR. It can be
mounted in any orientation but, when looking for a location,
please bear in mind that there must be approximately 50mm
(2”) clearance for the wiring harnesses at the back of the unit
to ensure that the cables will not be bent too sharply. There
must also be enough space to remove the Compact Flash card
at the front.
The module can be mounted by various means including
using double-sided tape or Dual-Lock™. A rigid mounting
can be made to a suitable bracket using the six M3 tapped
holes in its underside (see Appendix A for dimensions).
Standard Wiring Harnesses
Once a mounting position has been determined, the
components should be connected using the wiring harnesses
supplied. The figure below shows the standard electrical
connections to the unit.
If you are using the Pro DVR with a Stack Video Overlay
system, an adapter harness is available for that system. The
differences are described at the end of this chapter. Please
contact your Stack distributor if you need to purchase the
adapter wiring harness.
!
The wiring harnesses supplied by Stack are terminated with
the most commonly used connectors. If your equipment uses
different connectors, you will need to obtain appropriate
adapters from your Stack dealer.
