Configuration
STACK Digital Video Recorder
26
Users Guide
Re-Trigger while Active
0
Record
Input:
Recording:
Time (Seconds)
Switch closed twice
30 Sec
In this final example the timer is constantly re-set whilst the
Record Switch is on. This effectively adds 30 seconds to the point
where the Record Switch was last switched off. See Triggered
Record Notes below.
Triggered Record Notes
If the Record Switch is switched on when the trigger time is
complete, the DVR will continue to record.
The DVR takes approximately two seconds to start recording
from the moment the Record Switch is switched on. In
Triggered Mode the recording timer starts when the recording
actually starts.
Power Control
Set the time of inactivity in seconds after which the DVR should
power down, ie, change to low power stand-by mode. The DVR
will power back up when the Record Switch is next activated.
Setting this value to zero will power down the DVR immediately
after recording finishes.
Only choose “Never low power” if the DVR is being powered
from a permanent power source such as a vehicle battery or a
mains power supply.
