LAR 350
12
en
1x
(4)
9.1 Manual Operation with Tilt Function
In manual mode the laser plane is aligned by hand. Neither
self-levelling nor relevelling are active. The unit does not
level itself. If the tilt function is active, interferences
(shocks, vibrations) that could misalign the unit from its
exact original setting do not go unnoticed.
Place the laser unit in the appropriate working position
(vertical or horizontal). Press button (3) x 1 = switch on in
tilt mode. Press button (4) x 1 = activate manual mode.
The white LED (5) lights steadily. The blue (8) and green (9)
LEDs light steadily.
The laser beam rotates. Fine adjustments can still be made
within the first 30 seconds. The laser plane can be set up by
direction-finding or by taking measurements.
If any event occurs that could result in the laser unit being
deflected from its exact alignment and setting, the beam
ceases to rotate and the blue (8) and green (9) LEDs flash.
If this occurs, check the laser unit and set it up once again
if necessary.
The inclinometer (available as an accessory) can be used to
aid setting up the inclination.
If the tilt function is triggered, this must be acknowledged
by pressing button (3) or, on the remote control unit, by
pressing buttons (17) + (20). Only after this can you proceed
further.
(3)
1x
1x
(17)
(20)
(3)
1x
1x
