16
INTELLIPRO
®
2 VST Variable Speed Pump Installation and User’s Guide
The sensor for Thermal Mode is in the drive, on top of
the motor. This feature allows you to set a speed (450
RPM - 3450 RPM) that runs when the IntelliPro
®
2 VST
Variable Speed Pump goes into Thermal Mode. The
temperature level that you wish Thermal Mode to start
can also be set.
IMPORTANT NOTE:
This feature is for protection of the
pump. Do not depend on the Thermal Mode feature for
freeze protection of the pool. Certain situations could
cause the pump to sense a different temperature than
actual air temperature.
Your automation systems air temperature sensor should
be used to sense actual temperature. For example, if
the pump is located indoors, the temperature of the
room does not indicate the outdoor temperature. The
pump does not sense the water temperature.
THERMAL MODE
Disabled / Enabled - Default: Enabled
DISABLED/ENABLED
SET SPEED
40° F - 50° F (4.4° C - 10° C) Default: 40° F (4.4° C)
PUMP TEMPERATURE
Set Speed (750 RPM - 3450 RPM) Default 1000 RPM
THERMAL MODE
MENU
Pump Menu: Thermal Mode
12:15p
Pump Temperature
4
0
F
°
ThermMode
To access the Thermal Mode menu:
1. Check that the green power LED is on.
2. Press
Menu
.
3. Use
the
Down
arrow to scroll to “Thermal Mode”
and press
Select
.
4. The factory default for Thermal Mode is
“Enabled“. To disable Thermal Mode, press
Select
to highlight “Enabled”.
5. Press
the
Up
arrow - “Disabled” is displayed.
6. Press
Save
to save.
To Set Thermal Mode Speed and Pump Temperature:
Note:
Thermal Mode features are only accessible if
Thermal Mode is “Enabled”.
1. With “Thermal Mode” displayed on the screen,
press the
Down
arrow -
“Set Speed” is displayed.
The factory default is 1000 RPM.
2. Press
Select
to change the speed. The cursor will
highlight the first column (ones).
3. Use
the
Up
or
Down
arrows to set speed (450 -
3450 RPM).
4. Press
Save
to save the speed.
5. Press
the
Down
arrow to Pump Temperature (
the
temperature the pump will activate Thermal Mode,
default is 40° F/4.4° C).
6. Press
Select
to change the setting. The cursor
will highlight the first column. Can be set
40° F to
50° F (4.4° C - 10° C).
7. Press
Save
to save the temperature setting.
Note:
To cancel any changes, press
Back
to exit
without saving.
8. Press
Back
to exit.
Setting the Thermal Mode Pump Temperature
Thermal Mode Menu Options
12:15p
ThermMode
Set Speed
100
0
RPM
Setting the Thermal Mode Pump Speed
