9
INTELLIPRO
®
2 VST Variable Speed Pump Installation and User’s Guide
Set Temperature Unit
The default setting is Fahrenheit (°F). The pump can be
set to either Celsius (°C) or Fahrenheit (°F).
1. Check that the green power LED is on.
2. Press
Menu
.
3. Press
Select
to select “Settings”.
4. Use
the
Up
or
Down
arrows to scroll to “Device”
menu item. Press
Select
.
5. Use
Up
or
Down
arrows to scroll to "Temperature
Units" and press
Select
.
6. Use
Up
or
Down
arrows to choose Celsius (°C) or
Fahrenheit (°F).
7. Press
Save
to save. To cancel any changes, press
Back
to exit without saving.
8. Press
Back
to exit.
MENU
SETTINGS
Password Protection
The default setting for password protection is disabled.
When this feature is enabled, the pump display will
prompt for the password before allowing access to the
control panel and buttons.
The entered password is any combination of four (4)
digits.
Password
Protection
Enabled
12:15
750 RPM
Actual Speed
Running Speed 1
•
The pump can always be stopped by pressing
Start/Stop
, even when password protection is
enabled.
•
If the pump has been stopped, the pump cannot
be turned back on with
Start/Stop
while running
in manual mode.
•
Pressing
Start/Stop
when the pump is off will
return it back to the Running Cycles Mode and run
at the next scheduled run time. If the present time
is within the scheduled run time, the pump will run
the scheduled speed.
•
All functions including programming are disabled in
Password Protection Mode.
•
Screen will read “Enter Password” if any button
other than the
Start/Stop
button is pressed
•
Key icon displayed in the upper left side of the
screen when Password Protection is on.
Set Control Panel Language
To access the language menu:
1. Check that the green power LED is on.
2. Press
Menu
and press
Select
to select “Settings”.
3. Use
the
Up
or
Down
arrows and scroll to “Device”
and press
Select
.
4. Use
the
Up
or
Down
arrows to scroll to “Select
Language and press
Select
.
5. Use
the
Up
or
Down
arrows to choose the desired
language.
6. Press
Save
to select the control panel language. To
cancel any changes, press
Back
to exit without saving.
7. Press
Back
to exit.
Pump Menu: Settings
Set Screen Contrast
The default setting for the LCD screen is 3. Screen
contrast levels can be adjusted from 1 to 5 units for low
or high lighting conditions.
Note:
Changes to the contrast setting do not update
instantaneously. Changes to this setting must be saved
before the contrast level changes.
1. Check that the green power LED is on.
2. Press
Menu
.
3. Press
Select
to select “Settings”.
4. Use
the
Up
or
Down
arrow to scroll to “Device”
and press
Select
.
5. Use
the
Up
or
Down
arrow to scroll to “Contrast
Level."
6. Press
Select
. Screen will show current contrast
setting number. Use
Up
or
Down
to change
number.
7. Press
Save
to save. To cancel any changes, press
Back
to exit without saving.
8. Press
the
Back
button to exit.
Pump Address
(cont.)
5. Use
the
Up
or
Down
arrows to scroll to “Pump
Address” and press
Select
.
6. Press
Up
or
Down
arrows to change the address
number from 1-16.
7. Press
Save
to save. To cancel any changes, press
Back
to exit without saving.
8. Press
Back
to exit.
