Motor control operations
UM0522
30/39
Figure 18.
Programming option auto window
12. Press "start" to program the device.
If an error window appears, make sure that the inDART-STX board is connected to the
STEVAL IHM017.01 board and that the board is well supplied.
13. After programming check LED behavior to verify that the firmware has been correctly
downloaded.
8.14 Board
connection
After the board has been programmed, the system can be configured as shown in
. This configuration is called a "running configuration". Remove the ICC flat cable
from the board if present.
1.
Connect the insulated AC power supply to the J9 connector of STEVAL-IHM017V1.
2.
Connect the phases of the motor to the J8 connector of the board.
Figure 19.
System setup for running phase
www.BDTIC.com/ST
