Ashby-MF Insert
4
GENERAL INFORMATION SAFETY PRECAUTIONS
SAFETY NOTICE: The Ashby-MF must be properly installed in order to prevent the
possibility of a house fire! These installation instructions must be strictly observed! The
Maintenance schedule must be followed as described in this manual. Failure to follow
instructions may result in property damage, bodily injury or even death.
The Ashby-MF’s exhaust system works with negative combustion chamber pressure and a
slightly positive chimney pressure. Therefore, it is imperative that the air intake and exhaust
system be airtight and installed correctly. Do not install a flue damper in the exhaust vent of this
unit.
Do not connect this unit to a chimney flue serving another appliance.
BUILDING PERMIT
Contact the local building officials to obtain a permit and information on any local installation
restrictions and inspection requirements.
DEFINITION OF “INSERT”
The word “Insert” as used in this manual to describe the Ashby-MF is interpreted to mean an
Insert approved for Corn, Wheat, Rye, Cherry Pits and Distiller’s Grain.
This insert is not
intended as the sole source of heat.
EMISSIONS TESTING
The Ashby-MF is a “Non-Affected Facility” and was not tested to comply with U.S.
ENVIRONMENTAL PROTECTION AGENCY 2020 particulate emission standards using pellet
fuel.
The Ashby-P is certified to the 2020 Phase of ASTM E2779-2010. Heat Output: 7628 BTU/hr –
29916 BTU/hr, Efficiency: 65.5% using the higher Heat Value of the Fuel. Emission Rate .981
gr/h
SAFETY TESTING
The Ashby-MF has been independently tested and listed by Warnock Hersey Laboratories in
accordance with the proposed ASTM E 1509-2004 Standards and the applicable portions of UL
1482 and ULC S627/B366.2, and Oregon Administrative Rules 814-23-901 through 814-23-
909, stating requirements for installation the Ashby-MF and for mobile home installations. The
safety-listing label is located on the top of the hopper. Please refer to label for pertinent
information.
DISCLAIMER OF WARRANTY
Since Even Temp Company has no control over the installation of the Ashby-MF, Even Temp
Company grants no warranty, implied or stated, for the installation of the Ashby-MF and
assumes no responsibility for any special, incidental or consequential damages.
MANUFACTURED FOR:
Even Temp Inc., Hwy 34, Waco, NE, 68467, Phone: 1-402-728-5255
Save This Installation & Operations Manual
