8
RUNNING WIRING AND CABLES (RZR4)
D
B
C
A. Extract the (4) T40 surrounding the ride command system OR top-center dash
compartment (for non-Ride Command vehicles) and (2) push pins found in the
dash pocket. Unclip the dash surrounding the glovebox. Once unclipped, gently
pull the dash forward and remove the upper dash pocket.
D. Unwrap the tape and pull the rubber wire grommet out of the firewall.
B. Extract the (1) T40 torx that secures the lower dash pocket.
Disconnect the USB and unclip the LED from the lower dash pocket.
Remove the lower dash pocket.
C. Label / take photos of the harnesses connected to the dash. Once
recorded, disconnect harnesses, and remove dash.
A
E1
E2
E3
E. Starting from under the hood compartment, feed the connector of the power wire, MRB3 power connector, and B-H1912 & B-H1913 rear harness
female connector through the grommet into the dash cavity. In order to connect to the amplifier in a later step, pull about 18” of the amp power
wire and B-H1912 & B-H1913 into the dash cavity (E1). Route the additional length of the (ring terminal end) power/ground wire and B-H1912 &
B-H1913 down the exterior of the firewall along the factory wiring (E2). Pull the power/ground wire through to the center of the vehicle to the battery
compartment. DO NOT CONNECT TO THE BATTERY (E3). **NOTE** B-H1912 & B-H1913 is used for the addition of rear speakers - sold separately.