7
PANELS AND DASH DISASSEMBLY (RZR4)
D1
D2
D1. Remove hood by turning locking pins and lifting up.
D2. Unscrew the (4) T40 torx screws and extract the (2) push pins from
the top-center Ride Command bezel. Lift and remove the top-center
Ride Command bezel. From inside the machine, pull the dash
towards you to unclip. Once unclipped remove the dash.
RUNNING WIRING AND CABLES (RZR3)
A
A. Unwrap the tape and pull the rubber wire grommet out of the firewall.
B1
B2
B3
B. Starting from under the hood compartment, feed the connector of the power wire and B-H1912 & B-H1913 rear harness female connector through
the grommet into the dash cavity. In order to connect to the amplifier in a later step, pull about 18” of the amp power wire and B-H1912 & B-H1913
into the dash cavity (B1). Route the additional length of the (ring terminal end) power/ground wire and B-H1912 & B-H1913 down the exterior of the
firewall along the factory wiring (B2). Pull the power/ground wire through to the center of the vehicle to the battery compartment. DO NOT CONNECT TO
THE BATTERY (B3). **NOTE** B-H1912 & B-H1913 is used for the addition of rear speakers - sold separately.
