15
E. With the accurate location marked, uninstall the amp tray and use
a 13/64” drill bit to drill your pilot hole.
With your pilot hole drilled, reinstall the amp tray. Use the self-
tapping screw in the drilled hole location.
E
D. Using a scribe or punch, mark the location of the needed pilot hole
on the passenger side of the tray.
D
C. Secure the amp tray by using the 10mm factory bolt at the top, and
two (2) T-30 torx bolts at the bottom mounting locations.
C
F. Connect the amplifier “Front Input” to the Ride Command “Audio
Amp 1” factory harness. Connect the amplifier “Rear Input” for rear
speakers to “Audio Amp 2” factory harness. Connect the 800.5
input for the subwoofer to “Audio Amp 3” factory harness. Connect
the 800.5 output to the RZ4-GB10 subwoofer.
F
Connections for a RZR w/o factory speakers pre-installed
FRONT KICK PANELS (ALL MODELS)
Route the B-H1909 across the dash cavity. The cable marked as “DRIVER” will route under the dash and down to the driver side footwell, the cable
marked “PASSENGER” will route over the top and down the right side of the RZ4-GB10 enclosure.
PASSENGER
DRIVER
