14
AMP TRAY INSTALLATION (RZR3)
Place the pre-assembled amp plate on the frame of the dash and line up the hole on the top of the amp plate to the factory
hole where the pocket bracket was previously installed (1). Loosely screw in the factory 10mm screw in this hole location that
was previously removed. Next loosely screw in the T30 screw with washer from underneath the steering column into the amp
plate (2). Lastly hand tighten both screws.
1
1
2
2
Connect the 800.5 amplifier “Front Input” to the Ride Command
“Audio Amp 1” factory harness. Connect the 800.5 amplifier “Rear
Input” for rear speakers to “Audio Amp 2” factory harness. Connect
the 800.5 input for the subwoofer to “Audio Amp 3” factory harness.
A. Place the amp tray base bracket at the location of the (2) removed
factory 10mm bolts. Re-fasten the bolts through both the amp tray
base bracket and factory plate to secure to the chassis.
A
AMP TRAY INSTALLATION - WITHOUT FACTORY AUDIO (RZR4)
B. Place the amp tray into the mounting location by lining up the amp
plate screw holes to the factory holes on the chassis and base
bracket.
B
If you have factory speakers, you can remove the factory amplifier and
plug our harness into the factory 16 pin plug, which will allow for our
800.5 amp to be installed
