SSR Motorsports BISON 200P, Owner'S/Operator'S Manual

Page: 68 / 86

OWNER’S/OPERATOR’S MANUAL
16. MAINTENANCE
16- 12
Engine Oil Replacement
1. Place vehicle on a level surface;
2. Run engine two or three minutes until warm, Stop engine;
3. Clean area around drain plug;
4. Place a drain pan beneath engine crankcase.
5. Remove:

Oil filler plug

Drain plug

Compression spring

Oil strainer

O-ring
6. Allow oil to drain completely;
7. Install:

O-ring, New

Compression spring

Oil strainer
,
New, if necessary

Drain plug
,
and torque to 32N.m;
8. Using a funnel, fill the crankcase with 1.4L engine oil, refer to Recommended
Engine Oil ;
9. Check the oil level. refer to Engine Oil Level Inspection ;
10. Reinstall the Oil filler plug.
Transmission Lubrication
CAUTION
Be sure no foreign material enters the transmission case.
Transmission Oil Changing Procedure
1. Remove the four screws on the footwall and gently pull outward for access.
2. Remove the filler plug.
3. Remove the transmission drain plug located on the bottom left hand side and
drain the oil. Catch and discard used oil properly.
4. Clean and reinstall the drain plug and torque to 14 ft.lbs. (20Nm
）
5. Add the correct amount of SAE 80W/90GL5 lubricant until the oil reaches the
bottom of the filler hole.
6. Check for leaks.