11
Configuring FIELDBUS
3.2 CONFIGURATION / CONFLICT HELP MENU
This menu identifies and warns of accidental User programming that has connected a
single PIN to more than one GOTO.
R
ENTRY MENU LEVEL
ENTRY MENU LEVEL
1
1
CONFIGURATION
CONFIGURATION
2
2
ENABLE GOTO,GETFROM
ENABLE GOTO,GETFROM
An automatic conflict check is performed at the end of
each configuration session whenever you set
ENABLE
ENABLE
GOTO,GETFROM
GOTO,GETFROM
to DISABLED. This process repeats until
no conflicts are displayed.
It is not possible to make illegal connections (e.g. from
an output to an output). However, you can incorrectly
connect more than one
GOTO
GOTO
to a legal pin (e.g. an
input), resulting in an error at the target pin.
3.2.1 NUMBER OF CONFLICTS
Display the number of active GOTO conflicts.
PIN Parameter description
Range
772
NUMBER OF CONFLICTS
0 to 50
R
ENTRY MENU LEVEL
ENTRY MENU LEVEL
1
1
CONFIGURATION
CONFIGURATION
2
2
CONFLICT HELP MENU
CONFLICT HELP MENU
3
3
NUMBER OF CONFLICTS
NUMBER OF CONFLICTS
NOTE:
There will be at least two conflicts for each
conflict PIN. Removing one
GOTO
GOTO
from the conflict PIN
will reduce the conflict number by 1.
3.2.2 MULTIPLE GOTO ON PIN
Display the destination PIN of the first detected conflict.
PIN Parameter description
Range
773
MULTIPLE GOTO ON PIN
0 to 720
R
ENTRY MENU LEVEL
ENTRY MENU LEVEL
1
1
CONFIGURATION
CONFIGURATION
2
2
CONFLICT HELP MENU
CONFLICT HELP MENU
3
3
MULTIPLE GOTO ON PIN
MULTIPLE GOTO ON PIN
NOTE:
There will be at least two conflicts for each
conflict PIN. Removing one
GOTO
GOTO
from the conflict PIN
will reduce the conflict number by 1.
PIN 400 is "block disconnect". It indicates no conflicts.
When the "conflict checker"
finds a conflict:
1.
The message
GOTO
GOTO
CONFLICT
CONFLICT
is displayed.
2.
Correct the conflict.
