Spirent Landslide C100, Installation Manual

Page: 32 / 61

Landslide E10 System Overview
System Configuration Overview
32 | Spirent Landslide Test System Installation Guide
A typical field deployment is shown in Figure 3-4 .
Figure 3-4. Typical Field Deployment
System Configuration Overview
The general steps involved in configuring a Landslide test system are outlined below.
1
Install and power up the Landslide E10 combined Manager and Test Server(s).
2
Provide an IP address on your management network for the Manager and for each
Test Server.
Note:
The management network should be different from the test network that contains
the devices/systems under test.
3
Configure the Manager’s management port using the steps in “Landslide Manager
Configuration” on page 19 .
4
Configure each Test Server using the steps in “Landslide Test Server Configuration”
on page 19 .
After you have configured your Test Server, continue with the instructions in Chapter 5,
“Getting Started.”