Spirent Landslide C100, Installation Manual

Page: 18 / 61

Initial Installation
Standard Landslide System Configuration
18 | Spirent Landslide Test System Installation Guide
Standard Landslide System Configuration
Follow the instructions in this section to configure a standard system consisting of a
Landslide Manager and one or more Landslide Test Server(s).
System Configuration Overview
The general steps involved in configuring a Landslide test system are outlined below.
1
Install and power up the Landslide C100 Manager and Test Server(s) or the C50
combined Manager and Test Server.
2
Provide an IP address on your management network for the Manager and for each
Test Server.
Notes: •
For C50 test systems, a second management network IP address is required
only when the Add-on Test Server is part of the system configuration.
•
The management network should be different from the test network that
contains the devices/systems under test.
3
Configure the Manager’s management port by following the steps in
“Landslide Manager Configuration” on page 19 .
4
Configure each Test Server by following the steps in
“Landslide Test Server Configuration” on page 19 .
5
After you have configured your Test Servers, continue with the instructions in
Chapter 5, “Getting Started.”