F1 F2 F3 F4
F1 F2 F3 F4
F1 F2 F3 F4
Press
OK (F4)
to accept the value.
This is the lower temperature limit alarm value that can be associated
with a discrete output. An alarm code is generated when the
temperature value is below this limit. If no checking is needed, this
value should be set to zero.
Press
OK (F4)
to accept the value.
Note: If the programming menu was entered with a
Level 2
password,
then more menus will be shown that deal with factory set parameters
that should not be changed.
Calibration Parameters
This menu allows changing the factory calibrated setting of the
flowmeter and is accessible with a
Level 2
password. Calibration
parameter values are set for temperature and pressure at 0 degree C
and 760 mmHg.
These settings should normally never be changed except by
Spirax Sarco personnel at the factory.
This menu is entered from the base menu and pressing
FLO
,
PRM
and
CAL.
Press
CAL (F1)
then the display will show:
LoTmpAlm = 50 C
CHG OK
FLOW PARAMETER 2
CAL SPC PRM EXIT
CAL TABLE
TB1 - - - - - - EXIT
45
Operation: Programming
Programming
Using
the Local Display