F1 F2 F3 F4
F1 F2 F3 F4
F1 F2 F3 F4
F1 F2 F3 F4
Press
CHG (F1)
to change it and
OK (F4)
to accept.
After the pressure reference is accepted, the display will prompt for the
gas density if LBS or KG was selected for flow unit:
Press
CHG (F1)
to change and
OK (F4)
to accept.
Note: The density entry is only used when KG/time or LBS/time is
selected for flow rate units.
Density conditions are referenced to 0 C° at 760 mmHg.
Flow Parameters
This is the menu used to set various flow parameter values. They are:
Flow cutoff, pipe area, filter, high and low alarm for flow and temperature.
The menu is accessed from the base programming menu by pressing
FLO (F2)
:
Then press
PRM (F3)
:
Note: The CAL and SPC function key will only appear and be accessible
from a
Level 2
password.
DNS = 0.988876 KG/m3
CHG OK
SET PARAMETERS
I/O FLO DSP EXIT
FLOW PARAMETER 1
DGN UNT PRM EXIT
FLOW PARAMETER 2
CAL SPC PRM EXIT
42
Operation: Programming
Programming
Using
the Local Display