F1 F2 F3 F4
F1 F2 F3 F4
F1 F2 F3 F4
F1 F2 F3 F4
Press
YES (F4)
and the following screen will prompt the user to enter
the password if it is active:
Enter the correct password, then follow the instructions for changing a
value as specified above. The default Level 1 password is “1234”.
If the wrong password is entered, the message “Wrong Password” will
be displayed for a few seconds and then returns to the programming
entry screen.
If the password is accepted, the base programming screen will be
shown:
This is the base screen for the programming mode.
Press
EXIT (F4)
repeatedly until “Normal Mode” is seen briefly to exit
the programming mode.
Analog 4 to 20mA Output
The following menu allows the scaling of the analog 4 to 20mA outputs.
From the base screen, press
I/O (F1)
and
then in the next screen press
420 (F3)
.
PASWD:_
UP DN NXT OK
SET PARAMETERS
I/O FLO DSP EXIT
SET I/O
COM I/O 420 EXIT
SET PARAMETERS ?
No Yes
29
Programming
Using
the Local Display