Sperry Marine 5016-CA, Operation, Installaion And Service Manual

Page: 57 / 132

Analogue Compass Repeaters 056376/A
Configuring the Analogue Repeater with SUSI 6-5
15. To finish off the configuration, click in the SUSI applica-
tion to read all configuration and calibration settings from the ana-
logue repeater back into SUSI’s runtime memory.
A dialogue box will pop up, asking whether these parameters should
be saved as default settings for this device:
16. Click to save the parameters. The saved file is named “RCS-
default.xml“ and is located in the sub-directory “Parameter Files” in
SUSI’s installation directory.
To be able to retrieve and restore the configuration at a later point in
time, this file should be copied and saved to an appropriate location.
17. Fill out the analogue repeater setup table to retain an easily retrieva-
ble written record of the analogue repeater configuration.
18. Unplug the USB cable from the repeater and the service PC.
19. Power down the repeater and put the protective plug back on the
housing or reattach the cover to the connection box, respectively.
20. The configuration of the analogue repeater is now complete.
Note If a file “RCSdefault.xml“ already exists in SUSI’s “Parameter Files” sub-
directory, it will be overwritten without further warning.
To be able to retrieve and restore the configuration at a later point in
time, rename the file “RCSdefault.xml“ and/or copy it from the “Param-
eter Files” sub-directory to a different location.