Spengler CL Series, Service Manual, Page: 30 / 45

30
CL & PSL50 Series
REASSEMBLY
Step 17: Reinstall spout adaptor, mixers, Black Coffee Kit
Replace steam cover back onto
mixer body.
Hold red lever at 7:00 (unlocked)
position and fit mixer body into mixer
motor/housing (A), ensure retaining
tabs and steam extractor align
correctly and seat fully. Then secure
mixer in place by rotating it down to
6:00 (locked) position (B).
For dispensers with Black Coffee Kit
replace cover (A), connect tube to
stem at the back of vessel (B), then clip
vessel into bracket (C).
02 04
Align whipper disc to mixer shaft and
slid it into place until it ‘clicks’. (When
correctly installed approx. 1mm of
shaft should extend past front of the
disc).
01 03
Note:
The whipper disc must align with
the flat edge on the mixer shaft
when reinstalling.
i
i
Pro Tip:
In most cases if a mixer is very difficult to fully seat in order to lock it in place
the issue is that the steam trap is not properly aligned to the air channel and/or
the extractor stem, or the red locking lever is not being held at the 7:00 position,
thus causing it to interfere with the mixer housing.
To resolve any of these situations, simply remove the mixer, check all alignments
(steam trap, air channel, extractor stem and red locking lever) and try reinstalling
it again.
A
C
B
A
B