Chapter 2: Installation and Wiring
2-7
User’s Manual Pub. 0300307-01 Rev. A
WARNING
Hazard of damage to equipment.
The Spectrum Controls RTB hold down and terminal screws must be
tightened by hand using the guidelines in Step 5. They must not be
tightened using a power tool.
Use a slot screwdriver of 0.8 × 2.0 mm and carefully tighten to no more
than 2.2 Lb-in torque (0.25 Nm).
Failure to follow these guidelines may result in damage to your connector.
To install:
1.
Place the module next to the controller against the panel where you are
mounting the module.
2.
Mark drilling holes through the mounting screw holes and mounting feet,
and then remove the module.
3.
Drill the holes at the markings.
4.
Replace the module and mount it. Leave the protective debris strip in
place until you are finished wiring the module, and any other devices.
Wiring Diagram
Wire the module using the following table and image: OUT+3
RTB
Name
1
OUT+0
2
RTN0
3
OUT+1
4
RTN1
5
OUT+2
6
RTN2
7
OUT+3
8
RTN3
9
NC
10
NC
11
IN+4
12
RTN4
13
IN+5
14
RTN5
15
IN+6
16
RTN6
17
IN+7
18
RTN7
Summary of Contents for 2085-IF4XOF4-SC
Page 1: ......
Page 8: ...viii Micro800TM Analog Combination I O Module User s Manual Pub 0300307 01 Rev A...
Page 20: ...1 12 Chapter 1 Module Overview User s Manual Pub 0300307 01 Rev A...
Page 62: ...3 34 Chapter 3 Configuring the 2085 IF4XOF4 SC Using CCW User s Manual Pub 0300307 01 Rev A...
