Spectra Watermakers LB-1800C, Installation And Operating Manual

Page: 6 / 53

6
Fresh Water Flush
Pressing the ‘ Fresh Water Flush ’ button
flushes the watermaker with fresh water
from the vessel ’ s domestic water tanks.
After completing the flush, Spectra Con-
nect will automatically enter the Auto Store
mode.
Stop
Pressing the ‘ Stop ’ button from the Home
Screen will end the Auto Store mode
countdown timer and leave your watermak-
er in Standby mode.
When you first power up the system, you will get a warning message, asking if the sys-
tem has been stored with chemicals .
If the system has been pickled, winterized, this is the first startup, or the condition
of the system is unknown, go to COMMISSIONING or serious damage may occur.
Start
Pressing the ‘ Start ’ button once advances
to the Run Mode selection screen.
Spectra Connect Quick Start Guide
Run Mode
Select your desired Run Mode to start mak-
ing water and filling your tanks. See details
on Run Mode options on p. 37
Spectra Connect Modes and Definitions
Auto Store: After the watermaker fresh water flushes, it will start a countdown timer that
can be seen on the Home screen. The timer indicates the next programmed fresh water
flush if the watermaker is not started again, or the ‘ Stop ’ button is not pressed.
Fill Tank : The watermaker will automatically run until the Tank Full switch in the water
storage tanks closes. Once the Tank Full switch closes, the watermaker automatically
fresh water flushes, then reverts to the Auto Store mode.
Auto Run: The watermaker can be set to run for a number of hours, or for a quantity of
water to be produced. When the desired quantity of water is produced or the run timer
expires, the watermaker will Fresh Water Flush and enter the Auto Store mode.