Spectra Watermakers LB-1800C, Installation And Operating Manual

Page: 42 / 53

42
Dealer Access Settings
It is highly recommended that users consult with a factory trained technician before altering any settings
behind the ‘ Dealer Access Point ’. Changing this settings without understanding the full effect of
each change can void the warranty of your system, and cause irreparable damage.
If any settings are inadvertently changed, they can be reverted back to the defaults by using the
‘ Factory Reset ’ feature.
Other Setups—Default is all disabled
Automatic PRV: Enables an optional Automatic Pressure Relief Valve, after it is installed. This setting
should remain off unless you are certain that you have this feature installed on your system.
Power Sensor: Enables or disables an optional power sensor, after it is installed.
PH/ORP: Enables an optional pH or ORP meter, after it is installed.
Z - Ion: Enables or Disables the optional Z - Ion system, after it is installed. If the Z - Ion is enabled, you
should also adjust the Flush Interval to 30 days.
Tank Level Monitors
Tank Setup - Enable/disable tank sensors.
Enable Tank Switch High - Enable/disable tank high switch high. If this is disabled Auto Fill and Fill
Tank run modes will not be available.
Enable Tank Switch Low - Enable/disable tank high switch low. If this is disabled Auto Fill mode will
not be available. Both High and Low tank switches must be enabled for Auto Fill mode.
Enable Tank Level 1 - Enable/disable tank level sensor 1. If this is disabled there will be no tank level
reading and tank level gauge will read “!”.
Enable Tank Level 2 - Enable/disable tank level sensor 2..
Dealer Access Point—Settings cont...