RHD Series RHD
230/250/280
8
General Information
Always read this manual before fitting or operating the machine
– whenever
any doubt exists contact your dealer or the Spearhead Service Department for
advice and assistance.
Use only Spearhead Genuine Parts on Spearhead Equipment and
Machines
DEFINITIONS
–
The following definitions apply throughout this manual:
WARNING
An operating procedure, technique etc., which
–
can result in personal injury or loss of life if not observed carefully.
CAUTION
An operating procedure, technique etc., which
–
can result in damage to either machine or equipment if not observed carefully.
NOTE
An operating procedure, technique etc., which
–
is considered essential to emphasis.
LEFT AND RIGHT HAND
This term is applicable to the machine when attached to the tractor and is
viewed
from the rear
– this also applies to tractor references.
MACHINE DESCRIPTION & PURPOSE OF USE
The RHD
series of machines are ‘3-point linkage’ tractor mounted universal
flail mower/shredders designed primarily for the mulching of grasses,
brambles, small bushes, branches, vines, and general crop residues. Their
tough construction, working widths of 2.3, 2.5 or 2.8m and offset capability of
up to 0.5m makes them ideal for maintenance use in all green areas,
vineyards, orchards, on verges and in scrubland by farmers and contractors
alike.
These machines should only be used to perform tasks for which they were
designed
– use of the machine for any other function may be both dangerous
to persons and damaging to components and is therefore not advisable.
